Sukup Sweepway - Sweep Auger Operation Steps

To Next Page

To Previous Page

Operation

4. Turn on power. Center sump slide gate must remain FULLY open and sweep stop must be deployed

while sweep auger is operating. Remove remaining grain, making sure to reposition stop before each

revolution. NOTICE: Leave bottom panel of inner bin door closed when running sweep to avoid

possible damage to sweep wheel and/or door.

DANGER: When bin is nearly empty, sweep auger will travel at an increasingly fast speed.

Keep away from auger to avoid entanglement, which will result in death or serious injury.

5. Close sumps and place sweep just behind intermediate sumps.

NOTE: If a slower flow of grain is desired, (e.g., grinding) a larger driven pulley (12” comes standard)

should be used on unload auger. (14” pulley available from Sukup Manufacturing Co.)