Sulzer 16E - Replacing Common Parts; Front End Hardware

To Next Page

To Previous Page

16E / 16E-H / 16E-P Spray Gun

MAN 96150 EN 01

6.8 Replacing Common Parts

This section describes how to remove and install parts that may wear

out from normal use and parts that are configurable for different spray-

ing applications. (See “Hardware Selection” on page 26.) For com-

plete overhaul of the spray gun, see “Disassembly” on page 50 and

“Assembly” on page 59. For a complete list of replacement parts, refer

to the parts list, PL.96151.

6.8.1 Front End Hardware

Removal/Disassembly

1. Manually unscrew air cap body (33) from gas head assembly (75).

2. Remove air cap (29).

3. Using fingers only, carefully pull siphon plug assembly (18-28)

straight out from gas head assembly (75).

4. Manually unscrew nozzle nut (28) from siphon plug (20).

5. Using fingers only, carefully pull nozzle (23) out from siphon plug

(20).

6. Unscrew front wire guide (18) from siphon plug (20).

Assembly/Installation

1. Install four o-rings (22) on siphon plug (20).

2. Install two o-rings (25 and 26) on nozzle (23).

3. Apply a light coating of Krytox® lubricant to all o-rings.

4. Install front wire guide (18) on siphon plug (20).

16e_frontend