16E / 16E-H / 16E-P Spray Gun
52
MAN 96150 EN 01
3. Remove three screws (74) securing torsion ring cover (75) and
remove torsion ring cover.
4. Remove screw (76) from end cap (77) and end cap pin (78).
5. Carefully rotate torsion ring (79) counterclockwise, slightly,
increasing tension on torsion spring (81).
6. Push end cap pin (78) out of end cap (77) and carefully release
tension by allowing torsion ring (79) to rotate clockwise 1/2 turn.
7. Remove end cap (77), torsion ring (79), torsion spring (81) and
spring bushing (80).
8. Remove screw (93) securing safety handle (92) to pawl and shaft
assembly (84), slide out pawl and shaft assembly and remove
safety handle.
9. Remove screw (90) securing valve handle (89) to valve core (82)
and remove valve handle, compression spring (87) and detent pin
(88).
10. Push valve core (82) out through right side of gas head subassem-
bly (85).
To Next Page
Loading...