16E / 16E-H / 16E-P Spray Gun
60
MAN 96150 EN 01
4. Install plug (171) and o-ring (94) in front of gear cover (156).
5. Apply gasket sealant (Loctite 587 Blue, or equivalent) to both sides
of gasket (176).
6. Install gear cover (165) and gasket (176) on central housing (129)
and secure with four screws (156). Torque screws to 4.38-4.61 k-m
(38-40 lb-in).
7. Press ball bearing (159) onto drive shaft (173). Make flush with
gear cover (156).
8. Install nut (158) on drive shaft (173).
9. Press bearing (166) into gear cover (156). Bearing should be fully
recessed in gear cover.
10. Install countershaft gear (162) on countershaft (164) and secure
with set screw (9). Make sure set screw enters countersink on
shaft.
11. Install o-ring (161) on countershaft bearing retainer (160).
12. Assemble countershaft assembly (9, 162 & 164) and countershaft
bearing retainer (160). Press ball bearing (159) onto countershaft
assembly and secure with nut (158). Hold countershaft assembly
with glove or cloth and tighten nut.
13. Install countershaft plug (157) with o-ring (22) in countershaft bear-
ing retainer (160).
14. Install countershaft assembly (157-164) through rear of gear cover
(165). Press countershaft into inner race of ball bearing at front of
gear cover. Tighten countershaft bearing retainer.
15. Install turbine assembly. (See “Speed Control and Turbine” on
page 61.)
16. Install drive roll carrier, lower drive roll and lower drive gear. (See
“Drive Rolls and Gears” on page 47.)
To Next Page
Loading...