SunSetter EASYSHADE - TROUBLESHOOTING - OPERATION ISSUES; Remote Transmitter Failures; Motor and Battery Issues

10
Appearance
Problem Soluon
Fabric rolls up unevenly or
pulls to one side when the


 

 
Both the Aluminum Housing and the Cable Brackets must be installed on




Short lines appear in the


These are caused by clips required to secure the Solar Screen fabric to the


Operaon
Problem Soluon

to Open or Close the

 


CR2430
 











EasyShade moves 1 inch at



Motor will not respond to



The red light on the Remote


How to Replace Remote
Transmier’s Baery.
1. Remove and replace the Remote Transmier’s Baery
CR2430
 
 Remove back cover,
 
 
 
 Remove the back cover to allow it to dry out completely,
 
Note: An All Weather Remote Transmier is available for purchase from
SunSeer Products.