*Helper Needed*
Tools Needed
Parts Supplied
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY! PLEASE READ
THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING TO COMPLETE THIS INSTALLATION.
PRE-INSTALLATION NOTE
Note: Prior to installing your Solar Powered Motorized EasyShade, please review Figure 1 (Solar Powered
Motorized EasyShade Schemac View) then inspect to ensure that there are no obstrucons on your wall
surface, such as light xtures or door handles that would interfere with or block the Fabric Panel as it is
extended. For proper operaon you must ensure that the Aluminum Housing and Cable Guide Brackets are
mounted on the same vercal plane or surface.
Figure 4Figure 5Each of
the Brackets should be installed no more than 10” from the end of the Aluminum Housing. For the 10’ to 12’
models, the third Mounng Bracket should be installed at the mid point between the two End Brackets
Figure 2 - Parts Supplied
Round Head Screw
Cable Guide Stop
with Set Screw
Flat Head Screw
Bracket
Cable Guide Bracket
Solar Panel with
3 cord
not shown
Allen Set Screw for
Spare
Remote