13
Figure 21
Up Stop
To Change the Down Stop Posion:
Figure 23
and let it stop on its own
Figure 24
my
Adjusng the Up and Down Stop Posion
for the Motorized EasyShade
Follow these instrucons to change the
posion where the EasyShade stops. This is
for both the Up and the Down stop posions.
See Figure 21.
Note: Do Not exceed the 84” Down Stop Posion
Limit as this will cause the Fabric Panel to roll up
backwards in the housing. See Figure 21.
To Change the Up Stop Posion:
Move the EasyShade to its current Up (see Figure 22
let it stop on its own
Press and hold the (UPFigure 24
Press and hold the (MY
my
APPENDIX A
Figure 22
UP
Figure 23
Figure 24
Holding the
Note: Every EasyShade is programmed
by SunSeer to work on Channel 1
(see Figure 25) of the specic Remote
Transmier shipped with that Motorized
EasyShade. For more informaon, see
Page 7.
Figure 25
Channel 1
To Next Page
Loading...
Need help?
General
