SunStar KM-2070P SERIES - Sewing Method of Left;Right Scallop

3) Sewing Method of Left/Right Scallop
■ Operation Panel Indication Status
Ex) Selection shape No. 3 of Left scallop Pattern
■ Operation Order
1. Press left scallop key.
·Indication lamp of left scallop turns on. At the same time,
pattern number and shape number are displayed on the
indication device and after a moment, zigzag-width is
displayed.
2. Press PARA/SET key in order to change the shape number.
·ZigZag-width on indication device blinks and at the time,
pressing left scallop key, pattern number and shape
number are displayed on the indication device.
3. Change the shape number by using + and –key.
(Ex: selection of pattern shape no. 3)
4. Press PARA/SET key when the change is completed.
·ZigZag-width is displayed on the indication device.
5. You may start sewing by stepping on the pedal.
[Note]
·In case of right scallop, it is the same as the operation
method above.
Power On Start
Sewing
or
Indication Device
Pattern Number
Shape Number
10