SunStar KM-2070P SERIES - Basic Operation Panel Concepts

[In case of no parameter change] [In case of parameter change]
12) Up/Down Stop of Needle
13) Basic Concept for Operation of Operation Panel
- This setting is used to check location of sewing material correctly or it is usefully used for reverse function(mirror) and name
stitch sewing.
Setting method is to turn on the indication lamp of down stop by pressing up/down stop key of needle.
It is selected to initial value of down stop.
In case of up stop, you can just press down stop key once again.
Use PARA/SET key in order to change the selected parameters (width, base location, left/right stop location, etc.).
( See the operation order in case of [parameter change])
In order to use the set value in advance, turn on the indication lamp by selecting the desired key and start sewing.
(Operation order in case of [ no parameter change])
Basic concept of panel operation
[ Fig. 3-3 ]
Power on Status
Setting Pattern
Sewing
Lift/Right
stop
Start
Condense
ZigZag
Width
Base
Line
End
Condense
Power on status
Sewing
Parameter change
Setting of changing
parameter
23
R