SunStar KM-2070P SERIES - Setting of Base-Line

10) Setting of Base-Line
■ Indication Status of Operation Panel
- Location of base-line is set to ‘0’at the moment of shipping from factory.
- Lacation of base-line can be set up to 4[mm] in the left and right from on the origin.
■ Operation Order
Ex) Pattern is set to 2 point zigzag pattern and zigzag width is
set to 4[mm] in advance.
1. Press base-line key.
Location of base line is displayed on the indication
device
Initial location of base line is set to “r-00”.
2. Press PARA/SET key.
The indication device blinks
3. Decide left and right by pressing N1 key. (Ex : L-00)
4. Change the location by using + and - key.
(Ex : L-20)
5. Set the changed value by pressing PARA/SET key.
The changed location of base line is displayed on
the indication device.
6. Press zigzag width key.
Zigzag width is displayed on the indication device.
7. Start sewing by pedaling forward.
Power On Status
indicatin device
or
19
R