[ Fig. 3-6 ]Status of Operation Panel
16) Deciding Presser Foot Up/Down Location
1. Turn on the power.
Indication lamp of presser foot down turns on.(presser foot falls down thread trimming.)
2. Press presser foot up/down(①) key to change.
Indication lamp of presser foot up turns on. (presser foot always rises thread trimming.)
18) AUTO
In case of name stitch sewing, turning the indications lamp on by pressing AUTO key(③), the machine sews to the set stitch number by
stepping the pedal once automatically and it also perform automatic thread trimming after completing last sewing. (completing sewing
of the set vertical stitch number.)
17) Thread trimming and Wiper function
1. Turning the power on, functions of thread trimming and wiper are all selected.
2. In order to remove this function, turn the indication lamp off by pressing thread trimming/wiper key (② ).
19) Half Stitch Operation
When the sewing machine stopped, pressing the half stitch operation key (④ ), the machine performs half stitch sewing at low speed.
speed of half stitch sewing: 100 spm
Thread Trimming
EE
④④ ①① ②②②②
③③
EE
[ a ]
※ Sew is possible as much as the set
stitch number and thread
trimming is possible as well.
※ If AUTO lamp is ON, the machine
automatically executes thread trimming
at the completing point of sewing.
[ b ]
EE
AUTO on : automatic thread trimming
FF
FF
[ Fig. 3-5 ]E (vertical stitch number) sewing and name stitch sewing
28
To Next Page
Loading...
