8) Using method of start condence
■ Indication statas of Operation Panel
Ex) It is the example of pattern 3 with zigzag-width of 6mm.
■ Operation Order
1. Press start condense key on condition that power in on.
Lamp of start condense turn on, and A side stitch
number of start condense is displayed on the indication
device.
A side stitch number scope : 0~99 [stitch]
2. Press start condense key once again.
B side stitch number of start condense is displayed
on the indication device.
B side stitch number scope : 0~99 [stitch]
3. Press start condense key once again, then width of start
condense in displayed on the indication device.
width scope : 0~8.0 [mm]
4. Press zigzag-width key.
Zigzag-width is displayed on the indication device.
5. Start sewing by pedaling forward.
Execute the set start condense, and start sewing the
pattern shape.
6. Execute thread trimming by stepping back the pedal when
the sewing is completed.
<Caution>
If you turn on the indication lamp of start condense by pressing start condense key, sewing is possible on that condition as well.
If you pressed start condense then uses to see the setting status of start condense.
Adjustment of stitch width (see “3_20”) using reverse button.
A, D side stitch width : setting to feed adjustment dial
B, C side stitch width : setting to condense adjustment dial
Power On Status
Sewing
Indication Device
A side stitch number of
start condense
B side stitch number of
start condense
display width of
start condense
15
To Next Page
Loading...
