SunStar KM-2070P SERIES - Page 16

■ Changing stitch number and width of start condense
-Sewing type of start condense
■ Operation order.
1. Press start condense key on condition that power is on
Indication lamp of start condense turns on and A side
stitch number of start condense is displayed on the
indication device.
2. Change the number of stitch by using + and - key.
(Ex : 10 stitches )
3. Press start condense key once again.
B side stitch number of start condense is displayed on the
indication device.
4. Change the number of stitch by using + and - key.
(Ex : 10 stitches )
5. Press start condense key once again.
Width U is displayed on the indication device.
6. Press PARA/SET key to change width of start condense.
Indication PARA/SET lamp turn on and indication device
blinks at the same time.
7. Change the width by using + and - key. (Ex : 3 mm )
8. Set the changed value by pressing PARA/SET key.
Width is displayed on the indication device
9. Press zigzag-width key.
zigzag width is displayed on the indication device
10. Start sewing by pedaling forward.
<Note>
A , B side stitch number of start condense : 0~99 [stitch]
width of start condense : 0~8.0 [mm]
<Note>
Start speed of start condense is 1200spm (in case of
sew-speed is above 1200spm) and execute the set sew-
speed in case of sew-speed is below 1200 spm.
Power On Start
Indication device
or
or
or
A side stitch number of
start condense
B side stitch number of
start condense
Width of
start condense
Width of start
condense
Start point
A side stitch number of start condense
B side stitch number of start condense
Status of Sewing
A
B
reverse area
Change width
16