25
66
Sewing Preparation
1) Needle Installation
2) Lower Thread Placement
Place the lower thread as in the figure below.
A. Turn the hand pulley to make the needle holder ①
reaches the highest position.
B. Loosen the needle fixing screw ②. Make the long
groove of the needle ③ headed forward and then
fasten the fixing screw again ②.
①
③
②
Make sure to turn off the power before needle installation.
Otherwise, injury might occur due to the mistaken operation of the pedal.
Caution
Make sure to turn off the power before lower thread placement.
Otherwise, injury might occur due to the mistaken operation of the pedal.
Caution
To Next Page
Loading...
