7
SC8200 Series are designed as industrial sewing machines performing sewing on denim and
other similar materials. Please observe the following instructions during the machine operation.
ⓐ Read through this manual carefully and completely before operating the machine.
ⓑ Wear proper clothes for work.
ⓒ When the machine is in operation, do not bring your hands or body near the moving parts
of the machine, such as needle, looper, spreader, thread take-up lever and pulley, etc.
ⓓ Keep the covers and safety plates in place during operation.
ⓔ Be sure to connect the earthing conductor.
ⓕ Turn off the main power and check if the switch is turned “off”before opening electric
boxes such as the control box.
ⓖ Stop the machine before threading the needle or checking after work.
ⓗ Do not step on the pedal when turning the power on.
ⓘ Do not operate the machine with any cooling fan blocked.
The air-filter on control box must be cleaned once a week.
ⓙ If possible, install the machine away from source of strong electrical noise such as high
frequency welding machines
4) Operating
machine
Warning
Caution
[ Warning ]
Keep cover in place before operating, turn off power before inspecting or adjusting in order
to prevent physical injury from belt.
5) Safety devices
ⓐ
Safety label : Things to be kept in mind during operation are described.
ⓑ
Thread take-up lever cover : Prevents the contact between a body part and the thread take-
up lever
ⓒ
Safety plate : Prevents the contact between needles and fingers.
ⓓ
Motor cover : Prevents any potential accidents from occurring while a motor is in
operation.
ⓒ
ⓑ
ⓐ
ⓓ
To Next Page
Loading...
Need help?
General
