18
66
Preparation Before Use
6.1) Oil Supply
1) There is an oil tank to lubricate major moving parts of
the arm. Check the oil volume at the oil tank and make
sure that the oil tank is properly filled.
2) The arm has the indicator which indicates the
remaining oil volume at the oil tank installed to the
bed. Check the oil indicator and supply oil until it
reaches the max. mark.
3) There is an oil cap inside the bed gear box on the upper
bed. Check the remaining oil volume and fill the oil to
the half of the oil tank.
When using the machine after it has been unused for a long time, oil supply is a must. Use the
machine at 70% of the maximum speed for some two weeks and then use the machine at the full
speed. This could enhance durability of the machine.
Caution
To Next Page
Loading...
Need help?
General
