166
4.5.3.8 Replace bucket teeth.
Replace bucket teeth before bucket teeth holder
wears out.
Warning
It’s dangerous if the work equipment
moves by mistake when the teeth are
being replaced. Set the work
equipment in s table condition, stop
the engine, and then set the safety
lock levers securely to the LOCK
position.
If the lock pin is knocked out by force,
there is hazard that pins may fly out.
Check to ensure nobody is in the
surrounding area.
During replacement operation, there
is hazard of flying out pieces. So
wear protective glasses, gloves, and
other protective equipment.
Lower the bottom surface of the bucket on a
block, check that the work equipment is in a
stable condition, then set safety lock lever to
the LOCK position.
Place a metal rod (diameter is a little smaller
than pin) against the back of the pin), use
hammer to knock out pin (1), then remove
bucket teeth (2).
Clean mounting surface, place new bucket
teeth (2) to teeth holder, push pin (1) partly
into it by hand, then use hammer to knock in
lock pin to position it to bucket holder.
To Next Page
Loading...
