80
（5） After confirming min.and max.accelerograph dial position, press F4, calibrate
accelerograph, it must for 1 minute, it is normal for changing engine rev during
calibrating, please just, after system is normal, motor calibration state will cue you ‘it
has calibrated’.
（6） Press F1 go back
3.2.5.14 Loading counter interface
In this interface：
（1） Start/cancel loading counter function , or reset current loading number.
（2） Press F2 and F3 used to select loading counter and reset loading number, press F5
confirm.
（3） Press F1 go back。
F1 F2 F5F3
To Next Page
