To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the alignment notch at the
bottom.
Installing and Removing DIMMs
To Remove:
Use your thumbs
to gently push
the release tabs
near both ends of
the module. This
should release it
from the slot.
DDR2
Top View of DDR2
Possible System Memory Allocation & Availability
System Device Size Physical Memory
Remaining (-Available)
(4 GB Total System Memory)
Firmware Hub flash memory (System
BIOS)
1 MB 3.99
Local APIC
4 KB 3.99
Area Reserved for the chipset 2 MB 3.99
I/O APIC (4 Kbytes)
4 KB 3.99
PCI Enumeration Area 1
256 MB 3.76
PCI Express (256 MB) 256 MB 3.51
PCI Enumeration Area 2 (if needed)
-Aligned on 256-MB boundary-
512 MB 3.01
VGA Memory
16 MB 2.85
TSEG 1 MB 2.84
Memory available to OS and other ap
-
plications
2.84
To Next Page
Loading...
Need help?
General
