Release : 1.1f 105 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.67 duplex
This command configures the duplex operation and the no form of the command configures the
duplex operation to the default value.
duplex { full | half }
no duplex
Syntax Description
full - Port is in full-duplex mode
half - Port is in half-duplex mode
Mode
Interface Configuration Mode
Defaults
full
Example
SMIS(config-if)# duplex half
Certain ports can be configured to be either full duplex or half duplex. Applicability of this
command depends on the device to which the switch is attached.
Related Commands
negotiation - Enables auto-negotiation on the interface
speed - Sets the speed of the interface
To Next Page
Loading...
