Release : 1.1f 433 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.13 default-router
This command sets the default router in the DHCP server configuration parameters. The no form
of the command deletes the default router from the DHCP server configuration parameters.
default-router <ip address>
no default-router
Mode
DHCP Pool Configuration Mode
Example
SMIS(dhcp-config)# default-router 10.23.2.99
The configuration of this command will take effect only after configuring the network
address pool using network command.
Related Commands
service dhcp-server - Enables the DHCP server
show ip dhcp server information - Displays the server information
show ip dhcp server pools - Displays the DHCP server pools
show ip dhcp server binding - Displays the DHCP server binding information
show ip dhcp server statistics - Displays the DHCP server statistics
network - Configures the Network IP of the address pool
To Next Page
Loading...
