Release : 1.1f 149 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
4.1 Stack
This command enables stacking and helps configuring stacking ports, priority and switch
identifier.
stack { priority {PM | BM | PS} } {switchId <NodeId (1-16)>} {ports
<xg1,xg2,..>}
no stack
Syntax Description
Priority – Priority of the switch to decide the master among stacked switches. PM denotes
preferred master. BM denotes backup master. PS denotes preferred slave.
switchId - Unique number to identify switches. Make sure to use different switch identifier for
stack member switches.
ports – The list of stacking ports as xg1, xg2….. It is recommended to use two ports for
stacking to connect all stacking switches in daisy chain.
Mode
Privileged EXEC Mode
Defaults
Stacking is disabled.
Example
SMIS# stack priority PM switched 1 ports xg3, xg4.
Related Commands
show stackbrief – Displays summarized stack information
show stack details - Displays stack details
show stack counters - Displays stack port statistics
show stack switchid - Displays stack details for particular switch.
show stack link status – Displays the stacking interface link status.
To Next Page
Loading...
