Release : 1.1f 577 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.5 set ip pim rp-switchperiod
This command sets the period (in seconds) over which RP monitors register packets for switching
to the source specific shortest path tree.
set ip pim rp-switchperiod <0-2147483647(in secs)>
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim rp-switchperiod 100
To switch to SPT, this period must be configured RP-tree is a pattern that multicast packets are
sent to a PIM-SM router by unicast and then forwarded to actual recipients from RP
Related Command
show ipv6 pim thresholds – Displays threshold configured for SPT, RP thresholds, rate
limit values for both SM and DM
To Next Page
Loading...
