Supermicro SSE-X24S - Ip Pim Dr-Priority

Release : 1.1f 553 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.19 ip pim dr-priority
This command sets the designated router priority value configured for the router interface and the
no form of the command sets the default designated router priority value (0) for the router
interface.
ip pim dr-priority <priority(1-65535)>
no ip pim dr-priority
Mode
Interface Configuration Mode
Defaults
1
Example
iss (config-if)# ip pim dr-priority 100
The DR sets up multicast route entries and sends corresponding Join/Prune and Register
messages on behalf of directly-connected receivers and sources, respectively.
Related Command
show ip pim interface – Displays the routers PIM interfaces