Release : 1.1f 626 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
25.4 network
This command enables RIP on an IP network and the no form of the command disables RIP on
an IP network.
network <ip-address>
no network <ip-address>
Syntax Description
ip-address - IP address for the entry
Mode
Router Configuration Mode
Example
SMIS(config-router)# network 10.0.0.1
The network number specified must not contain any subnet information. RIP routing
updates will be sent and received only through interfaces on this network.
RIP sends updates to the interfaces in the specified networks. Also, if the network of an
interface is not specified, the interface will not be advertised in any RIP update.
Related Commands
router rip – Enables RIP on all the interfaces
show ip rip – Displays IP RIP protocol database or statistics
To Next Page
Loading...
