Release : 1.1f 907 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
permit - standard mode - Specifies the packets to be forwarded depending upon the
associated parameters
deny - standard mode - Denies traffic if the conditions defined in the deny statement are
matched
redirect - standard mode - Redirects traffic if the conditions defined in the redirect
statement are matched
permit- ip/ospf/pim/protocol type - Allows traffic for a particular protocol packet if the
conditions defined in the permit statement are matched
deny - ip/ospf/pim/protocol type- Denies traffic for a particular protocol packet if the
conditions defined in the deny statement are matched
redirect - ip/ospf/pim/protocol type- Redirects traffic for a particular protocol packet
if the conditions defined in the redirect statement are matched
permit tcp - Specifies the TCP packets to be forwarded based on the associated parameters
deny tcp - Specifies the TCP packets to be rejected based on the associated parameters
redirect tcp - Specifies the TCP packets to be redirected based on the associated
parameters
permit udp - Specifies the UDP packets to be forwarded based on the associated parameters
deny udp - Specifies the UDP packets to be rejected based on the associated parameters
redirect udp - Specifies the UDP packets to be redirected based on the associated
parameters
permit icmp - Specifies the ICMP packets to be forwarded based on the IP address and the
associated parameters
deny icmp - Specifies the ICMP packets to be rejected based on the IP address and
associated parameters
redirect icmp - Specifies the ICMP packets to be redirected based on the IP address and
associated parameters
ip access-group - Enables access control for the packets on the interface
show access-lists - Displays the access list configuration
To Next Page
Loading...
