Supermicro SUPERO X10DRU-i+ User Manual

Chapter 1: Overview
1-9
• Power-on mode for AC power recovery
• Intel
®
Intelligent Power Node Manager 3.0 (Available
when the Supermicro Power Manager "SPM" is in-
stalled and special power supply used. See the note
on Page 1-14.)
• Management Engine (ME)
System
Health
System Health/CPU Monitoring
Monitoring
• Onboard voltage monitoring for 3.3Vcc, 5Vcc, 12V,
Vcpu1/Vcpu2, VBAT, VDIMMAB, VDIMMCD, VDIMM
EF, and VDIMMGH voltages
• CPU/System overheat LED and control
• CPU Thermal Trip support
• Memory Fault Detection LEDs to indicate ECC errors
occurred on the DIMM module installed on each slot
• Status Monitor for Speed Control
• Status Monitor for On/Off Control
• CPU Thermal Design Power (TDP): support up to
160W (See Note 1 next page)
Fan Control
• Fan status monitoring via IPMI connections
• Dual Cooling Zone
• Low noise fan speed control
• Pulse Width Modulation (PWM) fan control
System
Management
• PECI (Platform Environment Conguration Interface)
2.0 support
• UID (Unit Identication)/Remote UID
• System resource alert via SuperDoctor 5
• SuperDoctor® 5, Watch Dog, NMI
• Chassis Intrusion Header and Detection
Dimensions
• 17.00" (L) x 16.80" (W) (431.80 mm x 426.72 mm)
Note 1: CPU Maximum Thermal Design Power (TDP) is subject to chassis
and heatsink cooling restrictions. For proper thermal management, please
check the chassis and heatsink specications for proper CPU TDP sizing.
Note 2: For IPMI Conguration Instructions, please refer to the Embedded
IPMI Conguration User's Guide available @ http://www.supermicro.com/
support/manuals/.

Supermicro SUPERO X10DRU-i+ Specifications

General

Brand	Supermicro
Model	SUPERO X10DRU-i+
Category	Motherboard
Language	English