Supermicro SuperServer E403-9P-FN2T - Page 83

Chapter 5: UEFI BIOS
83
• Oper. Firmware Version
• Backup Firmware Version
• Recovery Firmware Version
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCH SATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following features:
SATA Controller
This feature enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Disable and Enable.
Congure SATA as

AHCI and
RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives. The options
are Enable and Disable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity, and will return the link to an active state when I/O activity resumes. The op-
tions are Disable and Enable.
*If the feature "Congure SATA as" above is set to RAID, the following features will
be displayed:
SATA RSTe Boot Info
Select Enable to provide full int13h support for the devices attached to SATA controller. The
options are Disable and Enable.