3-5
Chapter 3: Troubleshooting
Question: Why do I get an error message “IASTOR.SYS read error” and "press F6
to install Intel RAID driver" when installing Windows on my motherboard?
Answer: To solve this issue, disable the IPMI jumper. Another solution is to use a
USB fl oppy drive instead of the onboard fl oppy drive. For the IPMI jumper location,
please check Chapter 1.
Question: What is the heatsink part number for my C7P67 motherboard?
Answer: For the 1U passive heatsink, ask for SNK-P0046P (back plate is included).
For the 2U active heatsink, use SNK-P0046A4.
Question: Why can't I recover the BIOS even when I’ve followed the instructions
in the user’s manual for the motherboard?
Answer: Please disable the IPMI jumper and try it again. For the jumper location,
please check Chapter 1.
3-4 Battery Removal and Installation
Battery Removal
To remove the onboard battery, follow the steps below:
Power off your system and unplug your power cable.1.
Locate the onboard battery as shown below.2.
Using a tool such as a pen or a small screwdriver, push the battery lock out-3.
wards to unlock it. Once unlocked, the battery will pop out from the holder.
Remove the battery.4.
Battery
Lock
Battery
Proper Battery Disposal
Warning! Please handle used batteries carefully. Do not damage the bat-
tery in any way; a damaged battery may release hazardous materials into
the environment. Do not discard a used battery in the garbage or a public
landfi ll. Please comply with the regulations set up by your local hazardous
waste management agency to dispose of your used battery properly.
To Next Page
Loading...
Need help?
General
