4-12
C7P67 User’s Manual
Hot-Plug
Select Enabled to enable hot-plug support for a SATA device installed in a
SATA port specifi ed by the user. The options are Enabled and Disabled.
When the option-RAID Mode is selected, the following items will appear.
SATA Port0~ SATA Port5
The AMI BIOS will automatically detect the presence of a device installed
in a SATA port specifi ed by a user, and displays the following items for
confi guration.
Hot-Plug
Select Enabled to enable hot-plug support for a SATA device installed in a
SATA port specifi ed by the user. The options are Enabled and Disabled.
PCIe/PCI/PnP Confi guration
This feature allows the user to confi gure the PCIe (PCI-Express)/PCI/PnP (Play and
Plug) settings for the following items:
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128,
160, 192, 224 and 248.
PCI Slot 1 Option ROM/PCI Slot 2 Option ROM/PCIe Slot 3 Option ROM/
PCIe Slot 5 Option ROM/PCIe Slot 7 Option ROM
Select Enabled to boot the system from a network device installed in a PCI-E or a
PCI slot specifi ed by the user. The options are Disabled and Enabled.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Load Onboard LAN3 Option ROM/Load Onboard LAN4 Option ROM
(X9SRE/i-LN4F Only)
Select Enabled to enable LAN OPROM for PXE. This is to boot computers using a
network interface. The options are Disabled and Enabled.
Boot Graphics Adapter Priority
This option allows the user to specify which graphics device to be used as the
primary boot device. The options are Onboard VGA and Offboard VGA.
To Next Page
Loading...
Need help?
General
