Supmeter BST106-B60S(L) - 5 Operation Procedure

12
Note: Parameter [203] ‘Data Compared with Weight Setpoints” can be defined to ‘0: Gross Weight’ / ‘1: Net Weight’
/ ‘2: Net Weight Peak Value’.
5. Operation Procedure
Relay DO Output Signal
Port
Application Mode / Parameter [212] AP
AP=1.HL
AP=2.HH
AP=3.LL
AP=4.SEC
DO1
[203]≤SET1
[203]≥SET1
[203]≤SET1
SET1≤[203]≤SET2
DO2
[203]≥SET2
[203]≥SET2
[203]≤SET2
[203]<SET1
或[203]>SET2
Connection & Power on
Zero Calibration
Other Settings
Key-locking
Scale Setting
Auto Zero Tracking Range &
Zero Fine Adjusting Range Setting
Setpoint Setting
[Data Calibration]
Load Calibration
[Segmenting Correction]