EasyManuals Logo

Suzhou Monarch Control Technology MCTC-GCB-A User Manual

Default Icon
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #167 background imageLoading...
Page #167 background image
NICE3000 User Manual System typical application and adjustment
167
mode is power failure emergency run, close K5, then open brake, the lift will auto-running; at
the same time monitor lift speed, till leveling.
7.5 Parallel program instruction
NICE 3000 integrated controller has the parallel control function. Two NICE 3000 control
systems can change and deal with the elevator information through CAN communication, thus
it can realize the function of two elevators
harmoniously correspond to the external call which
increase the lift efciency.
NICE 3000 systems parallel disposal logic adopts multi-principles integrated disposal,
covering call responding time, lift use efficiency, passengers waiting time in car and so on,
which enable to the advantages of the integrated controller. When the effective external call
has been registered, NICE 3000 system will ac
tually record the time two elevators responding
to the call (Considering distance, list stop door switch, etc.), and then responds to each call in
the most appropriate way thus reduce passengers waiting for the lift to the maximum extent.
The parallel program of NICE 3000 also includes parallel off, fastigium service, service oor
management, and collective selective management function and so o
n. Details are described in
chapter 6, corresponding instruction of function codes.
In parallel, the two lifts are main lift and subordinate lift. When the condition of responding to
the external call is totally the same, NICE 3000 system allocates the main lift or the subordinate
lift to respond to the call through random function. This can avoid the unbalance use of two
elevators.
7.5.1 Parallel s
etting
The following two function coders need setting to fulll the parallel function of NICE 3000.
Function code Name Setting Range Setting when parallel
F6-07 Group control quantity 1~8 2
F6-08 Lift number 12
Main lift: 1
Subordinate lift: 2
If the oor structure of two parallel lifts is different, other setting is needed. Details are explained
in the parallel case instruction of section 7.5.3.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzhou Monarch Control Technology MCTC-GCB-A and is the answer not in the manual?

Suzhou Monarch Control Technology MCTC-GCB-A Specifications

General IconGeneral
BrandSuzhou Monarch Control Technology
ModelMCTC-GCB-A
CategoryController
LanguageEnglish

Related product manuals