Structure of the control system and the component introduction NICE3000 User Manual
68
F0-00:1391
F0-01:2614
F0-02:479E,“E” is factory default,need no setting;
wiring b)
3 terminals are needed for GSM module:
CN1
Power supply terminal, 1 set 24v power supply, PE and NC need no wiring;
CH4
The interface of adjusting keypad sets the number by the adjusting keypad.
CN3
MCTC-MCB-A communication terminal, connect this terminal and the CN2 on the control board
by a communication wire, and
the wire is factory configured. 2 pins on the right side of J9
should be short;
Other terminals need no wiring;
jumper selection
There are 2 jumpers on the MCTC-IE-A-GSM board, and the 2 should all short to the left side
when using. Please refer to the measurement chart – short the 2 jumpers to “ON” side.
other configure
User need to add a general SIM card on the module•
Terminal CN2 of MCTC-IE-
A is communicated with the J1 of GSM, its factory default. •
3.9 Other optional components
3.9.1 Operation panel and communication cable(OPR、OPL)
Operation panel (OPR): MCTC-OPR-A.
Communication cable (OPL): MCTC-OPL0150, 0150 standing for 15m length.
Connection cable: MCTC-CCL0150, 0150 standing for 15m length.
If users need panel matched cable, they can choose the scope of cable with length 2m, 5m,
1
5m, 30m, 50m, and 100m.
3.9.2 Others
To coordinate with the use of NICE 3000 system, Suzhou Monarch Control Technology Corp.,
Ltd. provides other accessories such as group control board (MCTC-GCB-A), short message
control board (MCTC-IE-A), PDA adjusting machine (MCTC-PDA-A), Serial transferring to
parallel control board (MCTC-HPB-A), residential community monitoring interface board
(MCTC-BMS-A) and
etc. If you need any of them, please contact with the supplie