1D-46 Engine Mechanical:
• Apply bond to the mating surface of the left
crankcase.
• Assemble the crankcase within few minutes.
• Tighten the crankcase bolts to the specified torque.
NOTE
• Tighten the larger diameter crankcase
bolts first and then smaller ones
diagonally and evenly.
• Fit the cramp to the bolt “A”.
Tightening torque
Crankcase bolt (M6): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Crankcase bolt (M8): 26 N·m (2.6 kgf-m, 19.0 lb-ft)
• After the crankcase bolts have been tightened, check
if the each shaft rotates smoothly. If a large resistance
is felt to rotation, try to free the shafts by tapping them
with a plastic hammer.
Oil Pump
• Install the dowel pins.
• Install the oil pump (1).
• Install the washer (2) and pin (3).
LT-A400LT-A400F
I827H1140162-02
“A”
I827H1140164-01
I827H1140165-01
1
2
3
I827H1140166-01
To Next Page
Loading...
