Suzuki LT-A400F - Tightening Torque Specifications; Special Tools and Equipment; Recommended Service Material; Special Tool

Manual Transmission: 5B-14
Tightening Torque Specifications
B827H15207002
NOTE
The specified tightening torque is also described in the following.
“Gearshift Shaft / Gearshift Cam Plate Components (LT-F400/F) (Page 5B-10)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in
Section 0C (Page 0C-9)”.
Special Tools and Equipment
Recommended Service Material
B827H15208001
NOTE
Required service material is also described in the following.
“Gearshift Shaft / Gearshift Cam Plate Components (LT-F400/F) (Page 5B-10)”
Special Tool
B827H15208002
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Gearshift cam stopper nut 10 1.0 7.0 )(Page 5B-11)
Gearshift shaft stopper 19 1.9 13.5 )(Page 5B-12)
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 5B-9)
Sealant SUZUKI BOND No.1207B or
equivalent
P/No.: 99000–31140 )(Page 5B-8)
Thread lock cement THREAD LOCK CEMENT SUPER
1303 or equivalent
P/No.: 99000–32030 )(Page 5B-12)
THREAD LOCK CEMENT SUPER
1322 or equivalent
P/No.: 99000–32110 )(Page 5B-11)
09900–06107 09900–20102
Snap ring pliers Vernier calipers (1/20 mm,
200 mm)
)(Page 5B-4) / )(Page 5B-
8)
)(Page 5B-7) / )(Page 5B-
7)
09900–20803 09913–70210
Thickness gauge Bearing installer set
)(Page 5B-7) )(Page 5B-6) / )(Page 5B-
13)