1D-48 Engine Mechanical:
• Apply a bond lightly to the groove of the lead wire
grommet.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
Automatic Transmission
• Install the automatic transmission component parts
(1). Refer to “V-belt Type Continuously Variable
Automatic Transmission Removal and Installation in
Section 5A (Page 5A-7)” and “Clutch Shoe Removal
and Installation in Section 5A (Page 5A-16)”.
Oil Filter
• Install the oil filter. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-7)”.
Special tool
(A): 09915–40610 (Oil filter wrench)
Transfer Output Drive Gear
• Install the spacer (1).
• Install the transfer output drive gear (2) and new snap
ring (3).
CAUTION
!
Never reuse the removed snap ring.
Special tool
: 09900–06107 (Snap ring pliers)
Gearshift System
Install the transfer gearshift related parts. Refer to
“Transfer Gearshift Shaft No. 2 / Gearshift Cam Plate
Removal and Installation (LT-A400/F) in Section 3C
(Page 3C-17)”.
I827H1140172-01
1
I827H1140173-01
(A)
I827H1140174-01
1
I827H1140263-01
3
2
I827H1140264-01
I827H1140175-03
To Next Page
Loading...
