Front Suspension: 2B-4
5) Remove the front disc cover (6).
6) Remove the cotter pin, tie-rod end nut and washer.
7) Disengage the tie-rod end with the special tool.
WARNING
!
When using the tie-rod end remover, keep
clear of the tie-rod end because it may come
loose with some force and could strike you.
Special tool
(A): 09942–72410 (Tie rod end remover)
8) Remove the knuckle pinch bolts.
9) Remove the steering knuckle (7).
Installation
Install the steering knuckle in the reverse order of
removal. Pay attention to the following points:
• Apply grease to the lip of dust seals.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply thread lock to the steering knuckle pinch bolt
and tighten them to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Steering knuckle pinch bolt (a): 50 N·m (5.0 kgf-
m, 36.0 lb-ft)
6
I827H1220006-01
I827H1220007-01
(A)
I827H1220008-01
7
I827H1220038-02
I827H1220009-01
(a)
I827H1220039-01
To Next Page
Loading...
