2B-7 Front Suspension:
2) Remove the wheel hub bearings with the special
tools.
Special tool
(A): 09923–74511 (Bearing remover)
(B): 09930–30104 (Rotor remover slide
shaft)
Installation
Install the wheel hub bearings and steering knuckle dust
seals in the reverse order of removal. Pay attention to
the following points:
• Apply grease to the bearings and the lip of the dust
seals before installing them.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the wheel hub bearings using the special tool.
CAUTION
!
Removed bearing must be replaced with a
new one.
Special tool
(A): 09913–70210 (Bearing installer set)
NOTE
Install the outer bearing (1), spacer (2), and
then the inner bearing (3). Make sure the
sealed side of the bearing faces outside.
(A)
(B)
(A)
(B)
I827H1220017-01
I827H1220018-01
(A)
I827H1220019-01
1
3
2
(A)
1
(A)
I827H1220020-01
To Next Page
Loading...
