Drive Chain / Drive Train / Drive Shaft: 3A-4
3) Install the new snap ring to the cage.
CAUTION
!
Replace the snap ring with a new one.
Special tool
(A): 09900–06107 (Snap ring pliers)
4) Apply grease to the entire surface of the cage and
the inside of the outer race.
NOTE
The tube of joint grease is included in the
wheel side boot set or wheel side joint
assembly of spare parts.
5) Insert the cage into the outer race and install the new
stopper ring to the groove of the outer race.
CAUTION
!
• Replace the stopper ring with a new one.
• Position the opening of stopper ring “C”
so that it will not be lined up with a ball.
6) After installing the boot on the outer race, insert a
screw driver into the boot on the outer race side and
allow air to enter the boot so that the air pressure in
the boot becomes the same as the atmospheric
pressure at the positions indicated in the figure.
7) Fix the boot on the outer race with a new boot band,
taking care not to distort the boot.
Position
Wheel side Differential side
Grease: Quantity 45 g (1.6 oz) 60 g (2.1 oz)
(A)
I831G1310023-01
I831G1310013-01
I831G1310014-01
“D”: Right side “F”: Rotation direction
“E”: Left side “a”: 184 mm (7.24 in)
“C”
I831G1310015-01
A
“a”
VIEW A
“F”
“D”
“E”
“F”
I831G1310016-02
To Next Page
Loading...
