Suzuki LT-A400F - Page 419

Automatic Transmission: 5A-20
3) Remove the retainers (3).
4) Remove the bearing with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
NOTE
If there is no abnormal noise, the bearing
removal is not necessary.
5) Remove the oil seal with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Install the oil seal with the special tool.
CAUTION
!
• The removed oil seal must be replaced
with a new one.
• The marked side of the oil seal must face
the fixed drive face side.
Special tool
(A): 09913–70210 (Bearing installer set)
• Install the bearing with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
CAUTION
!
• The removed bearing must be replaced
with a new one.
• The sealed side of the bearing must face
the oil seal side.
3
I827H1510069-01
(A)
I827H1510070-01
(A)
I827H1510071-01
(A)
I827H1510072-01
(A)
I827H1510073-01