Steering / Handlebar: 6B-4
Installation
Install the handlebars in the reverse order of removal.
Pay attention to the following points:
• Insert the rear brake lever holder (1) and starter lever
(2) onto the handlebars.
• Apply handle grip bond “A” onto the left handlebar
before installing the left grip.
: Handle grip bond (Handle Grip Bond
(commercially available))
• When installing the handlebar lower holders, bring the
punch mark “B” backward.
• Set the handlebars so that its punch mark “C” aligns
with the mating surface of the left handlebar holder.
• Tighten the handlebar clamp bolts (3) to the specified
torque.
NOTE
First tighten the handlebar clamp bolts (3)
(front ones) to the specified torque.
Tightening torque
Handlebar clamp bolt (a): 26 N·m (2.6 kgf-m, 19.0
lb-ft)
• Connect the starter cable (4) to the starter lever.
• Insert the projection “D” of the left switch box into the
hole of the handlebars.
• Align the punch mark “E” on the handlebars with the
mating surface of rear brake lever holder.
• Tighten the rear brake lever holder clamp bolt.
1
2
I827H1620008-01
“A”
I827H1620010-01
“B”
I827H1620009-01
“C”
I827H1620012-02
“a”: Clearance
“a”
(a)
3
(a)
FWD
I831G1620013-01
“D”
4
I827H1620011-01
“E”
I827H1620013-03
To Next Page
Loading...
