Suzuki LT-A400F - Page 457

Steering / Handlebar: 6B-6
Tie-rod
1) Remove cotter pins and tie-rod end nuts and
washers.
2) Disconnect each tie-rod end using the special tool.
Special tool
(A): 09942–72410 (Tie rod end remover)
3) Loosen the lock-nut (1) and (2).
CAUTION
!
The lock-nut (1) have left-hand threads.
4) Remove the tie-rod end (3), lock-nut (1) and (2) from
the tie-rod (4).
Steering Shaft
1) Remove the speedometer and handlebars. Refer to
“Speedometer Removal and Installation in Section
9C (Page 9C-2)” and “Handlebars Removal and
Installation (Page 6B-3)”.
2) Remove the cotter pin and steering shaft lower nut.
3) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-13)”.
4) Remove the steering shaft holder bolts.
I827H1620019-01
I827H1620020-02
(A)
I827H1620021-01
1
3
4
2
1
3
3
2
4
3
I827H1620022-02
I827H1620023-01
I827H1620024-01