6A1-42 ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE)
D Ignition coil assembly
D Ground wires from
intake manifold
D EVAP canister purge
valve
D ECT sensor
D Injectors, TP sensor and
IAC valve wires at the
coupler
D Heated oxygen sensor 1
D MAP sensor
5) Remove intake manifold rear stiffener (1) and generator adjust
arm reinforcement (2) from intake manifold.
6) Disconnect the following electric wires:
and then release above wire harnesses from clamps.
7) Disconnect the following hoses:
D Brake booster hose (1)
D EVAP canister purge hose (3) from purge valve
D Radiator inlet hose
D Heater inlet hose
D IAC valve outlet (2)
8) Disconnect fuel feed (2) and return hoses (3) from fuel delivery
pipe (1).
To Next Page
Loading...
