ENGINE GENERAL INFORMATION AND DIAGNOSIS (TBI FOR G10) 6-17
DTC
NO.
DETECTING ITEM
DETECTING CONDITION
(DTC will set when detecting:)
MIL
P0705
Transmission range sensor (switch)
circuit malfunction (A/T)
No signal or multiple signals inputted with
shifted in “D” range
1 driving
cycle
P0720
Output speed sensor circuit
malfunction (A/T)
No signal while running vehicle with “D” or
“2” range.
1 driving
cycle
P0751
Shift solenoid A (#1) performance
or stuck off
While running in “D” range, engine speed as
2 driving
P0756
Shift solenoid B (#2) performance
or stuck off
lower than specified value.
cycles
P0753 Shift solenoid A (#1) electrical (A/T)
Output command from PCM and output
voltage do not agree (solenoid circuit
1 driving
P0758 Shift solenoid B (#2) electrical (A/T)
shorted to ground or open)
cycle
P1620 ECU code not registered
P1621
No ECU code transmitted from
Immobilizer Control Module
Refer to Section 8A.
P1622 Fault in ECM (PCM)
P1623 ECU code not matched