Swann AMI CACE - Maintenance (Main Menu 3); Operation (Main Menu 4); Clear Logger; Hold after Cal

AMI CACE
Program Overview
A-96.250.871 / 120417 47
8.3. Maintenance (Main Menu 3)
8.4. Operation (Main Menu 4)
Simulation Alarm Relay 3.1.1* *Menu numbers
3.1* Relay 1 3.1.2*
Relay 2 3.1.3*
Signal Output 1 3.1.4*
Signal Output 2 3.1.5*
Exchange EDI
3.2*
Set time (Date), (Time)
3.3*
Sensors Filter Time Const. 4.1.1*
4.10* Hold after Cal 4.1.2*
Relay Contacts Alarm Relay Cond. 1 (sc) Alarm High 4.2.1.1.1*
4.2* 4.2.1* 4.2.1.1* Alarm Low 4.2.1.1.25*
Hysteresis 4.2.1.1.35*
Delay 4.2.1.1.45*
Cond. 2 (cc) Alarm High 4.2.1.2.1*
4.2.1.2* Alarm Low 4.2.1.2.25*
Hysteresis 4.2.1.2.35*
Delay 4.2.1.2.45*
Relay 1/2 Parameter
4.2.2*/4.2.3* Setpoint 4.2.x.200*
Hysteresis 4.2.x.300*
Delay 4.2.x.40*
Input Active 4.2.4.1*
4.2.4* Signal Outputs 4.2.4.2*
Output / Control 4.2.4.3*
Fault 4.2.4.4*
Delay 4.2.4.5*
Logger Log Interval 4.3.1*
4.3* Clear Logger 4.3.2* * Menu numbers
Display Screen 1 Row 1 4.4.1.1*
4.4* 4.4.1* Row 2 4.4.1.2*
Row 3 4.4.1.3*
Screen 2 Row 1 4.4.2.1*
4.4.2* Row 2 4.4.2.2*
Row 3 4.4.2.3*