52 A-96.250.871 / 120417
AMI CACE
Program List and Explanations
3 Maintenance
3.1 Simulation
To simulate a value or a relay state, select
alarm relay
relay 1/2
signal output 1/2
with the [ ] or [ ] key.
Press the <Enter> key.
Change the value or state of the selected item with the [ ] or
[] key.
Press the <Enter> key.
The value is simulated by the relay/signal output.
At the absence of any key activities, the instrument will switch back
to normal mode after 20 min. If you quit the menu, all simulated val-
ues will be reset.
3.2 Exchange EDI
See Replacing the EDI module, p. 44.
3.3 Set Time
Adjust date and time.
Alarm Relay: Active or inactive
Relay 1/2: Active or inactive
Signal Output 1/2: Actual current in mA
Signal Output 3 (optional) Actual current in mA
To Next Page
Loading...
