78
Set the power roof ventilator’s three speeds
to attain the right air flow. The factory set
control voltages are Away = 2 V, Home = 5 V,
Boost = 8 V.
Speed settings:
• To activate setting mode, press fan speed
and lighting simultaneously and hold for
approximately 5 seconds.
• Setting mode is selected with the fan
speed button. The fan speed indication
shows which mode is being set. N.B.!
The fan speed mode can only be set from
lower to higher, for example, the Away
mode’s speed cannot be higher than Home
mode.
• The control voltage is increased with the
damper function button and is lowered
with the lighting button. The selected
control voltage is indicated as follows:
• The settings are saved by pressing and hol-
ding the lighting button for approximately
5 seconds. If the settings are not saved or
the cooker hood buttons are not touched
for ten minutes the cooker hood’s settings
return to normal mode and the set values
are not saved.
Not lit
Short flash
Long flash
Lit
1 V
2 V
3 V
4 V
5 V
6 V
7 V
8 V
9 V
10 V
To Next Page
Loading...
