13. STEERING/FRONT WHEEL/SUSPENSION
13-4
Place master cylinder onto handle and align its
connection surface with bolt hole on the handle
(disc brake).
Install the mounting seat.
Tighten the upper part bolt, and then tighten
lower bolt.
Install all components in reverse order of removal
procedures.
Conduct following adjustment:
y Oil pump control cable.
y Throttle operation.
Brake lever free play
Front Wheel
Removal
Remove speedometer cable from speedometer
gear box.
Remove front brake cable. (Drum type)
Remove front wheel axle nut, and then pull out
the axle and remove the wheel.
Bolt
Master cylinder
Speedometer cable
Axle nut
Axle nut
DISK TYPE
DURM TYPE
Brake cable
Speedometer cable
This chapter Contents
To Next Page
Loading...
