EasyManua.ls Logo

Sym DD 50 - Page 31

Sym DD 50
157 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. SERVICE MAINTENANCE INFORMATION
2-8
Brake System Hose: (Front Disc
Brake Type)
Make sure that the brake hose is corrosion or
damage, and also check the system for leaking.
Brake Fluid:
Check brake fluid level in the brake fluid reservoir.
If the level is lower than the LOWER limit, add
brake fluid DOT-3 to UPPER limit. Also check
brake system for leaking if low brake level found.
Caution
z In order to maintain brake fluid in the
reservoir in horizontal position, do not
remove the cap until handle bar stop.
z Do not operate the brake lever after the cap
had been removed. Otherwise, the brake
fluid will spread out if operated the lever.
z Do not mix non-compatible brake fluid
together.
Brake Lining Wear: (Rear Drum Brake
Type)
Replace the brake lining if the wear limit mark
” on the brake arm aligning with the indicator
of brake drum.
Brake Lining Wear: (Front Disc Brake
Type)
The arrow mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
In order to maintain brake power balance, the
brake lining must be replaced with one set.
Brake fluid
reservoir cap
Lower limit
Brake lining
Brake caliper
Brake disc
Wear limit mark
Arrow
This chapter Contents

Table of Contents

Related product manuals