SYMEO LPR-1DHP User Manual

SYMEO Local Positioning Radar System
LPR-1DHP
Product Documentation
Web Server for LPR-1DHP units with TCP/IP interface
Copyright © Symeo GmbH 2012
Page 22 of 40
Structure of the Settings page:
LAN:
Overview about LAN settings of
LPR-1DHP station (static or
dynamic IP address); see chapter
7.2.1.
Network:
Network settings; see chapter
7.2.2.
Serial-to-Ethernet:
Settings of parameterization port
and the data interface; see chapter
7.2.3.
Remote Access:
See chapter 7.2.4.
Miscellaneous:
Setting of time zone; see chapter
7.2.5.
Special Functions:
See chapter 7.2.6.
 Press button Upload changes to accept the changes of the LPR-1DHP station.
 Press button Reboot System to reboot the LPR-1DHP station with the new settings.
7.2.1 „LAN“ area
MAC-
Address
Unique hardware address of the LPR-1DHP station on the LAN (Ethernet
ID), (IEEE registered MAC adress, not editable)
Current
Mode
Shows the current mode:
"Static IP-Address" or "DHCP Active". Per default the IP-address is set to
the static IP-address 192.168.1.99.
In "DHCP Active" mode, the LPR-1DHP station receives a dynamic or
reserved IP address from the DHCP server. You can also ask your
administrator or the SYMEO technical department about this.

SYMEO LPR-1DHP Specifications

General

Brand	SYMEO
Model	LPR-1DHP
Category	Accessories
Language	English